3Com 3031 Command Reference Manual page 754

754 C 7: M
HAPTER ULTICAST
display multicast
routing-table static
display multicast
routing-table static
config
C C C
OMMON ONFIGURATION OMMANDS
When using this command, the system will prompt you to acknowledge. All static
multicast routes will be deleted after your acknowledgement.
For the related command, see ip rpf-route-static and display multicast
routing-table static.
Example
Delete all the static multicast routes.
<3Com] delete rpf-route-static all
Syntax
display multicast routing-table static [ source mask ]
View
Any view
Parameter
source: IP address of multicast source (unicast address).
mask: IP address mask of multicast source.
Description
Using the display multicast routing-table static command, you can view the active
multicast static routes.
If no multicast source address is specified, all active multicast static routes will be
displayed.
For the related command, see display multicast routing-table static config.
Example
Display all active multicast static routes.
<3Com> display multicast routing-table static
22.22.0.0/16 [inactive]
RPF interface = serial0/0/0, RPF neighbor = 66.55.99.88
Matched routing protocol = = <none>, route-policy = <none>,
preference = 1
Running config = ip mroute 22.22.0.0 16 66.55.99.88 preference 1
Display the multicast static routes that exactly match the address 10.10.0.0/16.
<3Com> display multicast routing-table static 10.10.0.0 255.255.0.0
Syntax
display multicast routing-table static config [ source mask ]
View
Any view
Parameter
source: IP address of multicast source (unicast address).