3Com 3031 Command Reference Manual page 528

528 C 5: N
HAPTER ETWORK
sdlc sap-map remote
sdlc simultaneous
P
ROTOCOL
For related configuration, please see the sdlc sap-map remote command.
Example
Configure the SAP address on translating the SDLC into the LLC2.
[3Com-Serial1/0/0] sdlc sap-map local 08 05
Syntax
sdlc sap-map remote dsap sdlc-addr
undo sdlc sap-map remote dsap sdlc-addr
View
Synchronous serial interface view
Parameter
dsap: The SAP address of the DLSw peer device. By default, dsap is 04.
sdlc-addr: The SDLC address.
Description
Using the sdlc sap-map remote command, you can configure the remote DLSw
device SAP address when SDLC is translated into LLC2. And using the undo sdlc
sap-map remote command, you can restore the default value.
When the SDLC packet is translated into the LLC2 packet, the SAP address is
needed besides the MAC address.
Generally speaking, the SAP address of the SNA protocol is 0x04 or 0x08 or 0x0C.
For related configuration, please see sdlc sap-map local.
Example
Configure the remote DLSw device SAP address when SDLC is translated into
LLC2.
[3Com-Serial1/0/0] sdlc sap-map remote 0C 05
Syntax
sdlc simultaneous
undo sdlc simultaneous
View
Synchronous serial interface view
Parameter
None
Description
Using the sdlc simultaneous command, you can configure the SDLC data to use
the bidirectional transmission mode. Using the undo sdlc simultaneous command,
you can stop the SDLC data to use the bidirectional transmission mode.
By default, the SDLC data are transmitted in bidirectional mode.