3Com 3031 Command Reference Manual page 741

MBGP Multicast Extension Configuration Commands 741
undo aggregate address mask [ as-set ] [ attribute-policy route-policy-name ] [
detail-suppressed ] [ origin-policy route-policy-name ] [ suppress-policy
route-policy-name ]
View
IPv4 multicast sub-address family view
Parameter
address: Address of the aggregated route.
mask: Network mask of the aggregated route.
as-set: Generates a route with AS_SET segment. This parameter is not
recommended to use when many AS paths are aggregated.
attribute-policy: Attributes of the aggregated route.
detail-suppressed: No detailed route but the aggregated route is advertised.
origin-policy: Filters the detailed route involved in aggregation.
suppress-policy: Detailed route determined is not advertised.
Description
Using the aggregate command, you can create a multicast aggregated record in
the BGP routing table. Using the undo aggregate command, you can remove the
aggregation.
By default, no route is aggregated.
Using the aggregate command without parameters, you can create one local
aggregated route and set atomic aggregation attributes.
Example
Create a multicast aggregated record in the BGP routing table and set the address
of aggregated route is 192.213.0.0.
<3Com-bgp-af-mul] aggregate 192.213.0.0 255.255.0.0
debugging bgp Syntax
mp-update
debugging bgp mp-update
undo debugging bgp mp-update
View
User view
Parameter
updates: Debug information of MBGP update packets.