3Com 3031 Command Reference Manual page 381

LAPB and X.25 Configuration Commands 381
Parameter
None
Description
Using the x25 response calling-address command, you can enable X.25 to carry
the address information of the calling DTE in sending call reception packet. Using
the undo x25 response calling-address command, you can disable the above
function.
By default, this function is disabled.
According to X.25, the call receiving packet of a call may or may not carry an
address code group, depending on the specific network requirements. This
command enables users to easily specify whether the call receiving packet of a call
sent by X.25 of the 3Com series routers carries the calling DTE address.
For the related commands, see x25 response called-address, x25 ignore
called-address, and x25 ignore calling-address.
Example
Specify that the call receiving packet of a call sent from the X.25 interface
Serial0/0/0 carries the calling DTE address.
[3Com-Serial0/0/0] x25 response calling-address
x25
Syntax
reverse-charge-accept
x25 reverse-charge-accept
undo x25 reverse-charge-accept
View
Interface view
Parameter
None
Description
Using the x25 reverse-charge-accept command, you can enable this interface to
accept the call with "reverse charging request", the information added by some
certain user facilities. Using the undo x25 reverse-charge-accept command, you
can disable this above function.
By default, this function is disabled.
This function does not affect any call without "reverse charging request".
If you enable this function on an X.25 interface, all these calls that reach the
interface will be accepted. If you enable this function for a certain address
mapping by the option reverse-charge-accept in the command x25 map, only such