3Com 3031 Command Reference Manual page 468

468 C 5: N
HAPTER ETWORK
apply ip-address
next-hop
apply ip-precedence
P
ROTOCOL
View
Route-policy view
Parameter
ip-address: IP address of default next hop.
Description
Using the apply ip-address default next-hop command, you can set the default
next hop of a packet. Using the undo apply ip-address default next-hop
command, you can cancel the configured default packet next hop.
This command is only valid for the packet whose route has not been found.
For the related commands, see apply ip-precedence, apply output-interface, apply
default output-interface, and apply ip-address next-hop.
Example
Set the default next hop of a packet to 1.1.1.1.
[3Com-route-policy] apply ip-address default next-hop 1.1.1.1
Syntax
apply ip-address next-hop ip-address [ ip-address ]
undo apply ip-address next-hop ip-address [ ip-address ]
View
Route-policy view
Parameter
ip-address: IP address of next hop.
Description
Using the apply ip-address next-hop command, you can set the packet next hop.
Using the undo apply ip-address next-hop command, you can cancel the
configuration about the next hop.
This command is used to set the next hop for the matched IP packet and at most
two next hops can be specified. The next hop should be adjacent to this device.
For the related commands, see apply ip-precedence, apply output-interface, apply
default output-interface, and apply ip-address default next-hop.
Example
Set the packet next hop to 1.1.1.1.
[3Com-route-policy] apply ip-address next-hop 1.1.1.1
Syntax
apply ip-precedence value
undo apply ip-precedence
View
Route-policy view