3Com 3031 Command Reference Manual page 671

apply origin Syntax
apply origin { igp | egp as-number | incomplete }
undo apply origin
View
Routing policy view
Parameter
igp: Sets the BGP route information source as internal route
egp: Sets the BGP route information source as external route
as-number: Specifies AS number of external route.
incomplete: Sets the BGP route information source as unknown source.
Description
Using the apply origin command, you can set the routing source of BGP routing
information. Using the undo apply origin command, you can cancel the apply
clause.
For the related commands, see if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, if-match tag, route-policy, apply ip-address,
apply local-preference, apply cost, and apply tag.
Example
Display how to define one apply clause. When it is used for setting routing
information attribute, it sets the routing source of the routing information as igp.
[3Com-route-policy] apply origin igp
apply tag
Syntax
apply tag value
undo apply tag
View
Routing policy view
Parameter
value: Specifies the tag value of route information.
Description
Using the apply tag command, you can set the tag area of OSPF route
information. Using the undo apply tag command, you can cancel the apply clause.
For the related commands, see if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, if-match tag, route-policy, apply ip-address,
apply local-preference, apply cost, and apply origin.
Example
Display how to define one apply clause. When it is used for setting route
information attribute, it sets the tag area of route information as 100.
[3Com-route-policy] apply tag 100
IP Routing Policy Configuration Commands 671