3Com 3031 Command Reference Manual page 566

566 C 6: R P
HAPTER OUTING
default type
ROTOCOL
undo default tag
View
OSPF view
Parameter
tag: Default tag, ranging from 0 to 4294967295.
Description
Using the default tag command, you can configure the default tag of OSPF when
it redistributes an external route. Using the undo default tag command, you can
restore the default tag of OSPF when it redistributes the external route.
When OSPF redistributes a route found by other routing protocols in the router
and uses it as the external routing information of its own autonomous system,
some additional parameters are required, including the default cost and the
default tag of the route.
For the related command, see default type.
Example
Set the default tag of OSPF imported external route of the autonomous system as
10.
[3Com-ospf-1] default tag 10
Syntax
default type { 1 | 2 }
undo default type
View
OSPF view
Parameter
type 1: External routes of type 1.
type 2: External routes of type 2.
Description
Using the default type command, you can configure the default type when OSPF
redistributes external routes. Using the undo default type command, you can
restore the default type when OSPF redistributes external routes.
By default, the external routes of type 2 are imported.
OSPF specifies the two types of external routing information. The command
described in this section can be used to specify the default type when external
routes are imported.
For the related command, see default tag.
Example
Specify the default type as type 1 when OSPF imports an external route.
[3Com-ospf-1] default type 1