3Com 3031 Command Reference Manual page 721

PIM Configuration Commands 721
Parameter
acl-number: Number of advanced IP ACL, defining the rule of filtering the source
and group addresses. The value ranges from 100 to 199.
Description
Using the register-policy command, you can configure a RP to filter the register
packet sent by the DR in the PIM-SM network and to accept the specific packet
only. Using the undo register-policy command, you can remove the configured
packet filtering.
Example
If the local device is the RP in the network, using the following command can only
accept the multicast data register packets sent by the source on the network
segment 10.10.0.0/16 to the multicast address in the range of 225.1.0.0/16.
<3Com> system-view
<3Com] acl number 110
<3Com-acl-adv-110] rule permit ip source 10.10.0.0 255.255.0.0
destination 225.1.0.0 255.255.0.0
<3Com-acl-adv-110] quit
<3Com] multicast routing-enable
<3Com] pim
<3Com-pim] register-policy 110
reset pim neighbor Syntax
reset pim neighbor { all | { neighbor-address | interface interface-type
interface-number } * }
View
User view
Parameter
all: All PIM neighbors.
neighbor-address: Specifies neighbor address.
interface: Specifies the interface.
interface-type interface-number: Interface type and interface number.
Description
Using the reset pim neighbor command, you can clear PIM neighbor.
For the related command, see display pim neighbor.
Example
Clear the PIM neighbor of the interface addressed with 25.5.4.3.
<3Com> reset pim neighbor 25.5.4.3
reset pim routing-table Syntax
reset pim routing-table all