3Com 3031 Command Reference Manual page 41

Information Processing Commands 41
Description
Using the info-center snmp channel command, you can set the information
channel for snmp. Using the undo info-center snmp channel command, you can
cancel the current configuration.
By default, channel 5 is used.
For the related command, see display snmp-agent statistics.
Example
Set snmp information channel to channel 6.
[3Com] info-center snmp channel 6
info center source
- Syntax
info-center source { module-name | default } { channel { channel-number |
channel-name} } [ log { state { on | off } | level severity }* | trap { state { on | off } |
level severity } * | debug { state { on | off } | level severity }* ]*
undo info-center source { module-name | default } { channel { channel-number |
channel-name }
View
System view
Parameter
module-name: Module name.
default: Sets the default information record.
channel-number: Information channel number to be set.
channel-name: Information channel name to be set.
log: Log information.
trap: Alarm information.
debug: Debugging information.
on: Enables outputting information.
off: Disables outputting information.
level: Sets information level to disable the output of the information at a level
higher than the specified severity.
severity: Information level. As shown in the following table, the info-center divides
information into eight levels by severity or emergency, with a lower level indicating
a more emergent event. emergencies indicates level 0 and debugging indicates
level 7.