3Com 3031 Command Reference Manual page 670

670 C 6: R P
HAPTER OUTING
apply isis
apply local-preference
ROTOCOL
apply isis [ level-1 | level-2 | level-1-2 ]
undo apply isis
View
Routing policy view
Parameter
level-1: Imports the matched route to Level-1 area.
level-2: Imports the matched route to Level-2 area.
level-1-2: Imports the matched route to both Level-1 and Level-2 area.
Description
Using the apply isis command, you can apply the level of a matched route to be
imported to Level-1, Level-2 or Level-1-2. Using the undo apply isis command, you
can remove the setting clause.
By default, no apply clause is defined.
For the related commands, see if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, if-match tag, route-policy, apply ip-address,
apply cost, apply origin, and apply tag.
Example
Define an apply clause to set the imported route to Level-2.
[3Com-route-policy] apply isis level-2
Syntax
apply local-preference local-preference
undo apply local-preference
View
Routing policy view
Parameter
local-preference: Newly set local preference.
Description
Using the apply local-preference command, you can apply the local preference of
route information. Using the undo apply local-preference command, you can
cancel the apply clause.
For the related commands, see if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, if-match tag, route-policy, apply ip-address,
apply local-preference, apply origin, and apply tag.
Example
Apply the local preference level of route information as 130 when this apply
clause is used for setting route information attribute.
[3Com-route-policy] apply local-preference 130