3Com 3031 Command Reference Manual page 220

220 C 3: I M C
HAPTER NTERFACE ANAGEMENT OMMANDS
the activation task and enter the active state. It will stay active as long as the line is
in good condition. The router tests the line performance at a regular interval and
will automatically deactivate the line and perform a new training and re-activation
once it finds out that the line performance has deteriorated.
Example
Deactivate the ADSL interface.
[3com-Atm1/0]undo activate
adsl standard
Syntax
adsl standard { auto | gdmt | glite | t1413 }
undo adsl standard
View
ADSL interface view
Parameter
auto: Auto-sensing mode.
gdmt: Adopts the G.DMT(G992.1) standard.
glite: Adopts the G.Lite (G992.2) standard.
t1413: Adopts the T1.413 standard.
Description
Using the adsl standard command, you can set the standard applied to an ADSL
interface. Using the undo adsl standard command, you can restore the default
standard used by the ADSL interface.
By default, the ADSL standard is set to auto.
You should note that this configuration does not take effect unless you activate
the interface again. If you want to make it take effect immediately, you can
execute the shutdown/undo shutdown command or the activate/undo activate
command.
Example
Set the standard for the interface atm1/0/0 as T1.413.
[3com-Atm1/0/0]adsl stand t1413
[3com -Atm1/0/0]shutdown
Interface Atm1/0/0 has already been shutdown
[3com -Atm1/0/0]undo shutdown