3Com 3031 Command Reference Manual page 553

[3Com-rip] preference 20
reset Syntax
reset
View
RIP view
Parameter
None
Description
Using the reset command, you can reset the system parameters of RIP.
When you need to re-configure parameters of RIP, this command can be used to
restore the default setting.
Example
Reset the RIP system.
[3Com-rip] reset
rip Syntax
rip
undo rip
View
system view
Parameter
None
Description
Using the rip command, you can enable the RIP and enter the RIP view. Using the
undo rip command, you can cancel RIP.
By default, the system does not run RIP.
To enter the RIP view to configure various RIP global parameters, RIP should be
enabled first. Whereas the configuration of parameters related to the interfaces is
not restricted by enabling/disabling RIP.
The interface parameters configured previously would be invalid when RIP is disabled.
Example
Enable the RIP and enter the RIP view.
[3Com] rip
[3Com-rip]
RIP Configuration Commands 553