3Com 3031 Command Reference Manual page 279

isdn overlap-sending
0 0 0
0 0 1
0 1 0
0 1 1
1 0 0
NI 1 1 0
0 0 0
0 1 0
0 1 1
1 0 0
NTT
The undefined bits in all the protocols are reserved for other purposes.
calling: Code scheme of the calling number.
called: Code scheme of the called number.
Description
Using the isdn number-property command, you can set type and code scheme of
ISDN calling numbers or called numbers. Using the undo isdn number-property
command, you can restore the default type and code scheme of ISDN calling
numbers or called numbers.
By default, the number type and code scheme are respectively unknown and ISDN
for both ISDN calling numbers and called numbers, and the number-property
representing them is 01 in hex format.
You are not allowed to configure this command on an ISDN interface if there is still
a call on it. This command can take effect only if it is configured when there is no
call on the interface. Alternatively, you can manually disable the interface by
executing the shutdown command, configure the command, and then enable the
interface by executing the undo shutdown command. The operations, however,
will lead to the disconnection of the call existing on the interface.
Example
Set both number type and code scheme of ISDN calling numbers on the interface
Bri 0/0/0 to unknown.
[3Com-Bri0/0/0] isdn number-property 0 calling
Syntax
isdn overlap-sending [ digits ]
undo isdn overlap-sending
ISDN Configuration Commands
0 0 0 0 Unknown number in Unknown numbering
plan
0 0 0 1 International number in ISDN numbering plan
(Rec. E.164)
0 0 0 1 National number in ISDN numbering plan (Rec.
E.164)
1 0 0 1 Network specific number in private numbering
plan
0 0 0 1 Local (directory) number in ISDN numbering
plan (Rec. E.164)
1 0 0 1 Abbreviated number in private numbering plan
Unknown
National number
Network specific number
Subscriber number
0 0 0 0 Unknown
0 0 0 1 ISDN/telephony numbering plan(
Recommendation E.164)
1 0 0 1 Private numbering plan
279