3Com 3031 Command Reference Manual page 778

778 C 8: MPLS B C C
HAPTER ASIC ONFIGURATION OMMANDS
Parameter
Index: Index of remote peer, used to identify an entity. It ranges from 0 to 99.
Description
Using the mpls ldp remote-peer command, you can create a remote-peer entity
and enter remote-peer view. Using the undo mpls ldp remote-peer command, you
can delete a remote-peer entity.
This command can create/delete a remote-peer so as to create remote session.
For the related command, see remote-peer.
Example
Create a remote-peer.
[3Com] mpls ldp remote-peer 22
[3Com-mpls-remote22]
Delete a remote-peer.
[3Com-mpls-remote22] undo mpls ldp remote-peer 12
[3Com]
mpls ldp reset-session Syntax
mpls ldp reset-session peer-address
View
Interface view
Parameter
peer-address: Corresponding LDP Peer address (in IP address format).
Description
Using the mpls ldp reset-session command, you can reset a specified session on an
interface.
After LDP is configured on an interface and LDP session is created, this command
can be used to reset a specified session on the interface only by specifying the
address of the peer corresponding to the session to be reset.
For the related commands, see mpls ldp and mpls ldp enable.
Example
Reset the sessions at the interface Ethernet0/0/0.
[3Com-Ethernet0/0/0] mpls ldp reset-session 10.1.1.1
mpls ldp timer Syntax
mpls ldp timer { session-hold session-holdtime | hello hello-holdtime }
undo mpls ldp timer { session-hold | hello }