3Com 3031 Command Reference Manual page 777

LDP Configuration Commands 777
Description
Using the mpls ldp password command, you can configure LDP authentication
mode. Using the undo mpls ldp password command, you can remove the
configuration.
Example
Configure the LDP authentication mode to be in plain text, with a password of
123.
[3Com-Ethernet0/0/0.1] mpls ldp password simple 123
mpls ldp path-vectors Syntax
mpls ldp path-vectors pv-number
undo mpls ldp path-vectors
View
System view
Parameter
pv-number: The configured maximum value of path vector, ranging from 1 to 32.
Description
Using the mpls ldp path-vectors command, you can set the maximum value of
path vector. Using the undo mpls ldp path-vectors command, you can restore the
maximum value of path vector.
By default, pv-number is 32.
This command should be configured before enabling LDP on all interface. Its
value, which depends on actual networking situation, decides the loop detection
speed in LSP creation.
For the related commands, see mpls ldp loop-detection and mps ldp hops-count.
Example
Set the maximum value of path vector to be 23
[3Com] mpls ldp path-vectors 23
Restore the maximum value of path vector.
[3Com] undo mpls ldp path-vectors
mpls ldp remote-peer Syntax
mpls ldp remote-peer Index
undo mpls ldp remote-peer Index
View
System view or remote-peer view