3Com 3031 Command Reference Manual page 820

820 C 8: MPLS B
HAPTER ASIC
display mpls te
link-administration
bandwidth-distribution
C C
ONFIGURATION OMMANDS
interface-num: Specifies interface number.
Description
Using the display mpls te link-administration admission-control command, you can
view local tunnels and their parameters (for example, priority, bandwidth, ingress,
egress and status).
By default, the admission control information of all RSVP interfaces will be
displayed.
For the related command, see display mpls te link-administration
bandwidth-distribution.
Example
Display the admission control information of all RSVP interfaces.
[3Com] display mpls te link-administration admission-control
System Information::
CrLsp Count: 4
CrLsp Selected: 4
CrLsp ID UP IF
10.106.0.6:1 AT1/0/0.2 -
10.106.0.6:2 Et4/0/1
10.106.0.6:3 Et4/0/1 Et4/0/2
10.106.0.6:4 AT1/0/0.2 AT0/0/0.2
Table 3 Display Information of Display mpls te link-administration admission-control
Display information
CrLsp Count
CrLsp Selected
CrLsp ID
UP IF
DOWN IF
PRIORITY
STATE
BW (kbps)
Syntax
display mpls te link-administration bandwidth-distribution [ interface
interface-type interface-num ]
View
Any view
Parameter
interface-type: Specifies interface type.
interface-num: Specifies interface number.
Description
Using the display mpls te link-administration bandwidth-distribution command,
you can view the information about the current link.
The displayed information may vary, in comparison with the actual configuration.
It depends on the flooding mode.
DOWN IF PRIORITY
0/0 0
- 1/1 0
1/13000
1/1 3000
Total number of tunnels accepted
Count of qualified tunnels
Tunnel ID
Upstream interface for the tunnel
Downstream interface for the tunnel
Priority for establishing and keeping tunnel
Administrative state
Bandwidth, in kbps
BW (kbps)
Description