3Com 3031 Command Reference Manual page 531

sdlc timer poll Syntax
sdlc timer poll mseconds
undo sdlc timer poll
View
Synchronous serial interface view
Parameter
mseconds: SDLC poll pause timer, ranging from 1 to 10000ms.
Description
Using the sdlc timer poll command, you can configure the SDLC poll pause timer.
Using the undo sdlc timer poll command, you can restore the default value of the
SDLC poll pause timer.
By default, the SDLC poll pause timer is 1000ms.
The SDLC poll pause timer refers to the waiting interval between the two SDLC
nodes polled by the SDLC primary station.
Example
Configure the SDLC poll pause timer as 200ms.
[3Com-Serial1/0/0] sdlc timer poll 200
sdlc window Syntax
sdlc window length
undo sdlc window
View
Synchronous serial interface view
Parameter
length: Length of the SDLC local response window, ranging from 1 to 7.
Description
Using the sdlc window command, you can configure the length of the SDLC local
response window. Using the undo sdlc window command, you can restore the
default length of the SDLC local response window.
By default, the default length of the SDLC local response window is 7.
The SDLC local response window refers to the maximum packets number that can
be sent continuously without waiting for the response from the peer end.
Example
Configure the length of the SDLC local response window on the Serial1/0/0 as 5.
[3Com-Serial1/0/0] sdlc window 5
sdlc xid Syntax
sdlc xid sdlc-address xid-number
DLSw Configuration Commands 531