3Com 3031 Command Reference Manual page 416

416 C 5: N
HAPTER ETWORK
dhcp server netbios-type
(in Interface View)
dhcp server netbios-type
(in System View)
P
ROTOCOL
For the related commands, see dhcp server ip-pool, dhcp server nbns-list (in
interface view), nbns-list, and netbios-type.
Example
In the DHCP address pool of interfaces in the range of Ethernet2/0/0.1 to
Ethernet2/0/0.5, assign the NetBIOS server at 10.12.1.99 to the clients.
[3Com] dhcp server nbns-list 10.12.1.99 interface ethernet 2/0/0.1
to ethernet 2/0/0.5
Syntax
dhcp server netbios-type { b-node | h-node | m-node | p-node }
undo dhcp server netbios-type
View
Interface view
Parameter
b-node: Broadcast mode, i.e., hostname-IP maps are obtained by means of
broadcast.
p-node: Peer-to-peer mode, i.e., maps are obtained by means of
communicating with the NetBIOS server.
m-node: Mixed (m) mode, i.e., the mode of type b nodes running
"peer-to-peer" communications mechanism.
h-node: Hybrid (h) mode, i.e., the mode of type p nodes possessing some of
the broadcast features.
Description
Using the dhcp server netbios-type command in interface view, you can configure
the NetBIOS node type of the DHCP clients of the current interface. Using the
undo dhcp server netbios-type command in interface view, you can restore the
default setting.
By default, clients adopt type h node (h-node).
Hostname-IP maps are required in the event that DHCP clients use the NetBIOS
protocol on a WAN.
For the related commands, see dhcp server ip-pool, netbios-type, dhcp server
netbios-type (in system view), and nbns-list.
Example
In the DHCP address pool of Ethernet1/0/0, set the NetBIOS node type of its clients
to p-node.
[3Com] interface ethernet 1/0/0
[3Com-Ethernet 1/0/0] dhcp server netbios-type p-node
Syntax
dhcp server netbios-type { b-node | h-node | m-node | p-node } { interface
ethernet-subinterface-range | all }
undo dhcp server netbios-type { interface ethernet-subinterface-range | all }