3Com 3031 Command Reference Manual page 720

720 C 7: M C C C
HAPTER ULTICAST OMMON ONFIGURATION OMMANDS
Parameter
None
Description
Using the pim sm command, you can enable PIM-SM protocol on an interface.
Using the undo pim sm command, you can disable PIM-SM protocol.
By default, PIM-SM is disabled.
Once PIM-SM is enabled on an interface, PIM-DM cannot be enabled on the same
interface and vice versa.
Example
Enable PIM-SM on the interface Ethernet1/0/0.
<3Com> system-view
<3Com] multicast routing-enable
<3Com] interface ethernet 1/0/0
<3Com-Ethernet1/0/0] pim sm
pim timer hello Syntax
pim timer hello seconds
undo pim timer hello
View
Interface view
Parameter
seconds: Interval of sending Hello message in second, ranging from 1 to 18000.
By default, the value is 30 seconds.
Description
Using the pim timer hello command, you can configure the interval of sending PIM
router Hello message. Using the undo pim timer hello command, you can restore
the default value.
Example
Configure the interval of sending Hello message on the interface Ethernet1/0/0 on
the PIM router to 40 seconds.
<3Com-Ethernet1/0/0] pim sm
<3Com-Ethernet1/0/0] pim timer hello 40
register-policy Syntax
register-policy acl-number
undo register-policy
View
PIM view