3Com 3031 Command Reference Manual page 559

3com 3031: reference guide

Hide thumbs Also See for 3031:

Table of Contents

Interface view

Using the rip work command, you can enable the running of RIP on an interface.

Using the undo rip work command, you can disable the running of RIP on an

By default, RIP is run on an interface.

This command is used in cooperation with rip input, rip output and network

For the related commands, see network, rip input, and rip output.

Disable the interface serial1/0/0 to run the RIP.

[3Com] interface serial1/0/0

[3Com-serial1/0/0] undo rip work

undo summary

Using the summary command, you can enable RIP-2 automatic route

summarization. Using the undo summary command, you can disable RIP-2

automatic route summarization.

By default, RIP-2 route summarization is enabled.

Route aggregation can be performed to reduce the routing traffic on the network

as well as to reduce the size of the routing table. If RIP-2 is used, route

summarization function can be disabled with the undo summary command, when

it is necessary to broadcast the subnet route.

RIP-1 does not support subnet mask. Forwarding subnet route may cause

ambiguity. Therefore, RIP-1 uses route summarization all the time. The undo

summary command is invalid for RIP-1.

For the related command, see rip version.

Set RIP version on the interface serial1/0/0 as RIP-2 and disable the route

summarization function.

RIP Configuration Commands