3Com 3031 Command Reference Manual page 444

444 C 5: N
HAPTER ETWORK
display fib
P
ROTOCOL
debugging udp packet
4.1.5
Syntax
debugging udp packet [ task_id socket_id ]
undo debugging udp packet [ task_id socket_id ]
View
User view
Parameter
task_id: The ID of a task.
socket_id: The ID of a socket.
Description
Using the debugging udp packet command, you can enable the debugging of
UDP connection. The number of debugging switches users can enable is limited,
that is, at the same time only a fixed number of debugging switches can be
enabled (combination of task ID and socket ID). Using the undo debugging udp
packet command, you can disable the debugging of UDP connection.
Example
Enable the debugging of UDP connection.
<3Com> debugging udp packet
<3Com> display debugging
*0.377770-SOCKET-8-UDP:
1043494431: Output: task = ROUT(6), socketid = 3,
src = 1.1.1.1:520, dst = 255.255.255.255:520, datalen = 24,
Syntax
display fib
View
Any view
Parameter
None
Description
Using the display fib command, you can view the summary of the Forwarding
Information Base.
This command outputs the Forwarding Information Base in a list, in which each
line represents one route. The following points are included:
Destination address/mask length
Next hop
The current flag, which is expressed in the combination of G, H and U. G
represents Gateway, H is Host (host route), and U is UP (available).
Time stamp