Avaya S8700 Maintenance Manual page 2030

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

Maintenance-Object Repair Procedures

Table 8-524. Test #5 Battery and Battery Charger Query Test — Continued

Description / Recommendation

2. If after 30 hours the battery is still in the high charge rate, an alarm will be

This indicates that error codes 2 and 4 have occurred. Refer to these

descriptions. Also, refer to this test's description for error code 14.

Issue 1 May 2002

raised. Display the Error Log with the display errors command and

select the category "environs" to display only environment-related errors.

Look for POWER errors of type 257. The first occurrence of this error

indicates the time when the battery started charging. Use this time as the

starting point to determine whether the battery has been charging for 30

hours. If so, then replace the battery and battery charger.

Read the section,

''Replacing the Battery and Battery Charger

(J58890CE)''

before proceeding. 3) Rerun the test. If the test

still fails, then the PN's MAINT (Maintenance) circuit pack could

be reporting this condition incorrectly. There are failures that

can occur on the PN's Maintenance circuit pack that will not be

detected by their respective maintenance, but which will cause

many, if not every, environment test to fail. If many environment

tests are failing, the suspect circuit pack, depending on the

system configuration, should be replaced and the test rerun.

Resolve every alarm on these MOs, and rerun the test.

Continued on next page

Troubleshooting