Avaya S8700 Maintenance Manual page 2033

POWER
Battery and Charger for DC-Powered Systems
MO's Name (in
Alarm Log)
POWER
1. UU is the cabinet number indicated in the PORT field from the Alarm or Error Log.
NOTE:
This MO applies to the J58890CE and the J58890CH-1 with large battery
holdover.
This MO represents the battery backup unit found in AC-powered multicarrier
cabinets. Because the system does not recognize the type of external power, this
MO exists in DC-powered multicarrier cabinets but serves no functional purpose.
In such cabinets, every POWER test should always either pass or abort, and no
POWER alarms should be raised.
S8700 Multi-Connect systems support two different types of PN cabinets:
multicarrier and single-carrier. Both cabinet types may be powered by either AC
or DC external power source. Environmental maintenance differs according to
cabinet type and external power supply.
Error Log Entries and Test to Clear Values
Table 8-525. Battery and Battery Charger Error Log Entries
Error Aux
Type Data Associated Test
1
0 0 Any
1 Any Battery and Battery Charger
Query test (#5) (error code 8)
257 Any Battery and Battery Charge
Query test (#5) (error code 4)
769 Any Battery and Battery Charger
Query test (#5) (error code 2)
3840 (a) 1005, Associated Battery and Battery
1028 Charger Query test (#5)
1. Run the short test sequence first. If every test passes, run the long test sequence. Refer to each appropriate
test's description, and follow its recommended procedures.
Note:
a. This error occurs is valid only for AC-powered multicarrier cabinets with
battery backup. For DC-powered cabinets, you cannot clear the error and
it should be ignored.
555-233-143
Alarm Initial SAT Command
1
Level to Run
MINOR test environment UU
Alarm
Level
Any
MINOR
MINOR
MINOR
Full Name of MO
Battery and Battery Charger
On/Off
Board Test to Clear Value
Any test environment UU sh r 1
ON test environment UU s r 1
ON test environment UU s r 1
ON test environment UU s r 1
test environment UU s r 1
Issue 1 May 2002 8-1311