Avaya S8700 Maintenance Manual page 1972

Maintenance-Object Repair Procedures
Error Log Entries and Test to Clear Values
Table 8-508. Packet Interface Error Log Entries
Error Aux
Type Data Associated Test
1
0 0 Any
1 (a) Any None
10 (b) 0 None
50 (c) 0 None
257 (d) Any None
513 (e) Any None
769 (f) Any Maintenance
Loop-around test
(#886)
1025 (g) Any Private Loop-around
test (#885)
1281 (h) Any None
1537 (i) Any Memory Checksum
test (884)
1793 (j) Any Memory Checksum
test (#884)
2049 (k) Any None
2305 (l) Any None
2561 (m) Any Active-Standby Peer
Link test (#888)
2817 (n) Any Read and Clear test
(#887)
3074, Any Maintenance
3073, Loop-around test
3072 (o) (#886)
3585 (p) Any None
3841 (q) Any None
1. Indicates that an alarm was raised but an associated error was not entered into the hardware error log due to a
momentary overload condition caused by a burst of hardware or software error reports. Run the long test
sequence. Refer to each appropriate test's description, and follow its recommended procedures.
2. A Packet Interface circuit on an active IPSI can only be reset if it has been taken out of service by
background maintenance software.
independent of its service state.
8-1250 Issue 1 May 2002
Alarm On/Off
Level Board
Any ON
MAJOR ON
MAJOR ON
MAJOR ON
MAJOR ON
MAJOR ON
MAJOR ON
MINOR ON
MINOR ON
WARNING ON
MINOR OFF
MINOR/ ON
MAJOR
WARNING OFF
WARNING OFF
MAJOR OFF
A Packet Interface circuit on a standby IPSI can be reset
Test to Clear Value
test packet-interface Uc l r 2
reset packet-interface Uc
reset packet-interface Uc
reset packet-interface Uc
test packet-interface Uc s r
2
reset packet-interface Uc
reset packet-interface Uc
test packet-interface Uc l r 2
test packet-interface Uc l r 2
test packet-interface Uc r 25
test packet-interface Uc r 2
test packet-interface Uc s r
2
test packet-interface Uc s
test packet-interface Uc s r
2
reset packet-interface Uc
reset packet-interface Uc
555-233-143
2
2
2
2
2