Commands For Software Load Management - Allied Telesis SwitchBlade x3100 Series Manual

Commands for Software Load Management

software load is "cfc200_14.2.0.GAMMA.20100716.tar" (as previously set by the user using the SET
CARD=ACTCFC PREFLOAD command). The IP address of the designated network boot server is 10.52.65.38.
TABLE 1-16
Step Command
Configure the IP address of the boot server (where preferred CFC software load resides)
set bootserver ipaddress 10.52.65.38
1
Configure the path on boot server (where preferred CFC software load is located)
set bootserver path x3112Files/
2
Verify the new boot server settings
show bootserver
3
-------------------------------------------------------------------------------
Network Boot Host IP..... 10.52.65.38
Network Boot Load........ cfc200_14.2.0.GAMMA.20100716.tar
Network Boot Path........ x3112Files/
1.8.4 Commands for Software Load Management
TABLE 1-17
Commands
SET BOOTSERVER
SHOW BOOTSERVER
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
Procedure - Configuring the Boot Server
Software Load Management Commands
Description/Notes
Sets the IP address of the network boot server
to 10.52.65.38
Sets the path (on the network boot server) to
"x3112/"
Introduction
1-117