Allied Telesis SwitchBlade x3100 Series Manual page 654

Introduction
SET TACPLUS AUTHMODE (SEC)
Syntax
SET TACPLUS AUTHMODE={ LOGIN | COMMAND }
Used to change the authentication mode for use with RADIUS servers. When the
Description
TACACS+ authentication mode is set to LOGIN, the user will be logged in with the priv-
ilege level assigned by the TACACS+ server.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Example
SET TACPLUS AUTHMODE=LOGIN
6-94
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Option Description
AUTHMODE The SET TACPLUS AUTHMODE command is used to
change the authentication mode for use with TACPLUS
servers.
When the TACACS+ authentication mode is set to
LOGIN or COMMAND, the USER privilege level is
requested by the client and either accepted or rejected
by the server. The user is always logged in at the USER
privilege level and must run the ENABLE {MAN-
AGER|SECURITYOFFICER} command to request
increased privilege.
Configuring a TACACS+ Server
Default Value
LOGIN