Introduction
SHOW TRACE AUTHENTICATION
Syntax
SHOW TRACE AUTHENTICATION [INTERFACE={type:id-range|id-range|
ifname-list|ALL}] [TYPE={DOT1X}] [EVENT={{SUCCESS|FAILURE|LOGOFF}
[,...]|ALL}]
Shows various tracing parameters for Port Authentication.
Description
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Example
SHOW TRACE AUTHENTICATION
--- Auth Message Trace ---
Interface Type
--------- --------- --------------------------------------------------------
ETH:11.19 802.1X
6-134
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Option
Description
INTERFACE
The ethernet interfaces over which the trace parame-
ters will be shown.
TYPE
The type of authentication. In release 14.2, only DOT1X
is supported.
EVENT
Specifies the type of Port Authentication event to add:
SUCCESS - Authentication has succeeded, and so a data
session can begin.
FAILURE - Authentication has failed.
LOGOFF - The supplicant has logged off, and the port
returns to an unauthorized state.
Event
Success,Failure,Logoff
Configuring Port Authentication
Default Value
ALL
DOT1X
ALL