Setdefaults Dot1X Interface - Allied Telesis SwitchBlade x3100 Series Manual

Configuring Port Authentication

SETDEFAULTS DOT1X INTERFACE

Syntax
SETDEFAULTS DOT1X INTERFACE={type:id-range|id-range|ifname-list|
ALL} [CONTROLDIRECTION] [EAPOLVERSION] [REAUTHMAX] [TXPERIOD]
[EAPREQMAX]
This command is used to reset the specified 802.1X-based Port Authentication interface
Description
settings to their default. If no parameters are specified, all settings are reset.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
INTERFACE
CONTROL-
DIRECTION
EAPOLVER-
ION
REAUTH-
MAX
TXPERIOD
EAPREQ-
MAX
Example
SETDEFAULTS DOT1X INTERFACE=6.22-6.23 EAPOLVERSION
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Description
The interface(s) over which the DOT1X parameters are
to be set.
BOTH - Except for authentication packets, traffic is
blocked in both directions until authentication is com-
plete.
The EOPOL protocol version.
Number of reauthentication attempts that can occur
before becoming unauthorized.
The period in seconds between successive request ID
attempts.
This parameter is only applicable when EAPOLVERSION
is set to 1
Number of EAP requests to send to a supplicant. This
parameter is only applicable when EAPOLVERSION is
set to 1.
Introduction
Default Value
ALL
BOTH
2
2
30
2
6-123