Leds; Installation Options; Management Software And Interfaces - Allied Telesis x530 Series Installation Manual

Chapter 1: Overview

LEDs

Installation
Options
Management
Software and
Interfaces
24
Note
The switches do not support the 7-meter AT-SP10TW7 direct attach
cable.
Note
For a current list of supported transceiver modules refer to the x530
Series Data Sheet.
The following restrictions on SFP+ transceivers apply:
100Mbps transceivers are not supported

Supports full-duplex mode only

The port LEDs are:
Link/activity LEDs for the copper ports on all switches

Link/activity LEDs for the SFP and SFP+ transceiver ports on all

switches
Full/Half/Collision LEDs for the copper ports on the

x530-28GTXm and x530-52GTXm switches
PoE+ LEDs for the copper ports on the x530-28GPXm and x530-

52GPXm switches
PoE++ LEDs for the copper ports on the x530-10GHXm and x530-

18GHXm switches
Switch ID number LED

The installation options are:
Desk or tabletop

19-inch equipment rack

Wood or concrete wall

The management software and interfaces are:
AlliedWare Plus Management Software

Command line interface (CLI)
