Allied Telesis SwitchBlade x3100 Series Manual page 482

Introduction
SETDEFAULTS EPSR
Used to reset the values of hello time, failover time, or ringflap time back to defaults.
Description
This operation is only allowed when the EPSR domain is disabled.
Syntax
SETDEFAULTS EPSR={ epsrdomain-list | ALL } [ HELLOTIME ] [
FAILOVERTIME ] [ RINGFLAPTIME ][ENHANCEDRECOVERY]
The following table gives the range of values for each option that can be specified with
Options
this command and a Default Value (if applicable).
Example
SETDEFAULTS EPSR=allied-2 HELLOTIME
4-162
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Option Description
EPSR The name(s) that has been given to the EPSR
domain(s)
HELLOTIME The rate at which the EPSR protocol Health con-
trol message is sent by the master node for this
EPSR domain.
FAILOVERTIME Time for which the master node waits before
declaring that it has detected a break in the ring for
this EPSR domain.
RINGFLAPTIME The minimum number of seconds that a master
node must remain in the failed state (before mov-
ing to the complete state), even if the ring has
recovered from its fault condition.
ENHANCEDRE- Allows a partial recovery of the ring even if there
COVERY are links that are down.
EPSR and (R)STP Interaction
Default Value
N/A
1
2
0
OFF