Allied Telesis SwitchBlade x3100 Series Manual page 553

Configuring IGMP
SET IGMPSNOOPING
Syntax
SET IGMPSNOOPING { CARD={ slot-list | ALL }
{ MCASTGROUPLIMIT=1..512 } | INTERFACE={ type:id-range | id-range |
ifname-list | ALL }
SNOOPINGMODE={ INTERNAL | EXTERNAL | MCPASSTHROUGH } |
[ FLOODUNKNOWNS={ ON | OFF } ]
[ ROUTERAGEINGTIMER=10..1200 ]
[ GENQUERYTIMER=5..120 ]
[ DUPREPORTTIMER=5..120 ] }
The SET IGMPSNOOPING command is used to set various configurable IGMP settings in
Description
the switch. These being setting the multicast stream count per slot, the flooding of
unknown multicast packets, and various timers are options you can set.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
CARD
MCAST-
GROU-
PLIMIT
INTERFACE
Software Reference for SwitchBlade x3100 Series Switches (Internet Group Management Pro-
tocol (IGMP))
Description
The interface from which the MAC address was learned
The number of multicast groups for a card. When this
number is exceeded, an alarm is raised against the card,
The interface(s) for setting the MCASTGROUPLIMIT
Introduction
Default Value
512
5-21