Allied Telesis SwitchBlade x3100 Series Manual page 120

Introduction
A USB slot is physically present on the faceplate, but there is no software support in 14.2. (USB
Note:
support will be available in a future release.)
The following SD flash memory cards are officially supported in the first release.
SanDisk 2GB Flash card
•
SanDisk 4GB SDHC Flash card
•
Others brands can be used but are not guaranteed to work.
Note:
The SD cards are labeled as "SD4" (on the slot 4 CFC) and "SD5" (on the slot 5 CFC) and are managed via the
MEDIA commands. The SD cards (on both the active and inactive CFC) can be used in all commands that allow
media devices for either source or destination files, including:
BACKUP DATABASE
RESTORE DATABASE
BACKUP CONFIG
PUT LOG
COPY FILE
DELETE FILE
PUT FILE
RENAME FILE
SHOW FILE
The RESTORE CONFIG is not supported from the SD card in 14.2 for either CFC.
Note:
Following are some sample input commands with the 2GB SD card.
show media
--- Media Devices ------------------------------------------------------
Unit
-------------------------------------- ---------------------------------
SD4
SD5
-------------------------------------------------------------------------
show media sd5
-------------------------------------------------------------------------
Device Name
Fault
Parent Card
Card Type
State
Status
Serial Number
Firmware Version
Number of Sectors
Bytes per Sector
Model
-------------------------------------------------------------------------
1-90
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
State
UP Online
UP Online
SD5
No Faults
5
SD MEDIA
UP
Online
1894278981
8.0
3862528
512
SD02G
CFC Media (SD Card)