Show Bfd - Allied Telesis SwitchBlade x3100 Series Manual

Configuring BFD

SHOW BFD

Syntax
SHOW BFD [ INTERFACE [ ={ type:id-range | id-range | ifname-list |
ALL } ] ] [ FULL ]
Shows the BFD configuration. For state information, the user enters the SHOW INTER-
Description
FACE command since State information does not show up in SHOW BFD.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
INTERFACE
Example
SHOW BFD INTERFACE ALL
--- Bi-directional Forwarding Detection Configuration Data ---
Interface Status
--------- -------- ------------ ------------ --------------- ---------------
8.18 Enabled
8.19 Enabled
8.22 Enabled
11.0 Enabled
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
Description
---- Protocol State ----
Local Remote
Up Up
Up Up
Up Up
Up Up
------ Interval Settings ------
Local
5 x 500 ms
5 x 500 ms
5 x 500 ms
5 x 500 ms
Introduction
Default Value
Remote
5 x 500 ms
5 x 500 ms
5 x 500 ms
5 x 500 ms
7-133