Allied Telesis SwitchBlade x3100 Series Manual page 805

Configuring an SNMP Community
SHOW SNMP (SEC)
Syntax
SHOW SNMP
The SHOW SNMP command displays information about the device's SNMP agent. SNMP
Description
configuration and SNMP counters are displayed.
N/A
Options
Example
>SHOW SNMP
------------------------------------------------------------------------
SNMP Configuration:
------------------------------
Status........................ Enabled
Authentication Failure Traps.. Disabled
Community..................... system_test
Access...................... READ-ONLY
Status...................... Enabled
Traps....................... Disabled
Open Access................. On
SNMP Counters:
------------------------------
inPkts........................ 116
inBadVersions................. 0
inBadCommunityNames........... 116
inBadCommunityUses............ 0
inASNParseErrs................ 0
inTooBigs..................... 0
inNoSuchNames................. 0
inBadValues................... 0
inReadOnlys................... 0
inGenErrs..................... 0
inTotalReqVars................ 0
inTotalSetVars................ 0
inGetRequests................. 0
inGetNexts.................... 0
inSetRequests................. 0
inGetResponses................ 0
inTraps....................... 0
------------------------------------------------------------------------
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
outPkts....................... 2
outTooBigs.................... 0
outNoSuchNames................ 0
outBadValues.................. 0
outGenErrs.................... 0
outGetRequests................ 0
outGetNexts................... 0
outSetRequests................ 0
outGetResponses............... 0
outTraps...................... 2
Introduction
7-67