Ufo Example Configuration (Static) - Allied Telesis SwitchBlade x3100 Series Manual

UFO Example Configuration (Static)

TABLE 4-21
Forwarding Mode
RESTRICTED
STP
EPSR
UCP
4.7.3 UFO Example Configuration (Static)
In a simple configuration, a UFO can be used to provide a permanent (static) Forwarding Mode, since these will
never have to change. Refer to the following figure.
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Forwarding Modes for UFO VLANs
Description
The VLAN cannot be used by all interfaces
at the same time.
The Spanning Tree Protocol will dynamically
determine the upstream interface.
The VLAN(s) are part of an EPSR configura-
tion and the EPSR protocol determines the
UPSTREAM interface.
The UCP protocol will determine the
UPSTREAM interface dynamically regardless
of the type of configuration.
Line Card Slot 8
Port 0
FORWARDING =
V_60
DOWNSTREAM
UFO_Mode_VLAN_Cnfg
UFO Model - Static Configuration
FIGURE 4-19
Notes
This is not used on the SBx3112.
Upstream is towards Root Bridge (refer
to Overview of Spanning
Upstream is towards EPSR Master (refer
to Ethernet Protection Switched Ring
(EPSR) and SuperLoop
Upstream is determined by UCP protocol
(refer to
(UCP)).
SBx900
FORWARDING =
PRIMARYUPSTREAM
Port 0
SBx3100
V_60
Line Card Slot 8
Port 4
FORWARDING =
= VLAN in UFO Mode
DOWNSTREAM
Introduction
Trees).
Prevention)
Upstream Control Protocol
4-167