Alliedview Nms Profile Support; Feature Operation - Allied Telesis SwitchBlade x3100 Series Manual

Introduction
Direction....................... Customer
1.17.3.2 Setting an Interface to No Profile
If the user wishes to disassociate an entity with any Profile, two double quotes are used. Whatever profile the
entity was associated with is dropped and the entity has <none> for a Profile association.
>SET INTERFACE 3.0 PROFILE=""
Info (020186): Successfully modified interface(s) 3.0
>SHOW INTERFACE=3.0
--- GE Interfaces ---
Interface.......................... 3.0
Type............................... GE
State.............................. UP-DN-Dependency
Description........................ <none>
Remote ID.......................... <none>
External Profile................... <none>
Card Type.......................... GE24POE
Provisioning
Provisioning Profile............ <none>
Direction....................... Customer
----------------------------------

1.17.4 AlliedView NMS Profile Support

1.17.4.1 Overview
The AlliedView NMS product also has a profile feature, but at a network service level; a profile is created for a
card type or port type, and can then be applied to multiple interfaces over multiple devices. Moreover, profiles
can include a more global set of attributes, such as traffic and performance management attributes. Finally, the
profiles are filled out using pull-down menus and GUIs, ensuring there is less chance of error.
Refer to the AlliedView NMS Administration Guide for a complete description of profiles.
Note:
When the NMS sets the port attributes by deploying an NMS profile, the
SBx3112 displays the NMS profile name that has been applied as an External Profile name. Moreover, if at the
NMS a port is deprovisioned, the product output for External Profile is set to None.

1.17.4.2 Feature Operation

NMS profile names can be set against any root interface of a card or any interface that can be dynamically
•
created after a card is provisioned. Interfaces include ETH (for XE4, GE24POE, and GE24SFP) and any
future interfaces.
LAG interfaces are explicitly excluded from support by this feature as they have no corresponding profile in
•
the NMS. These interfaces reject NMS profile name setting.
1-230
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
AlliedView NMS Profile Support
command on the
SHOW INTERFACE