Add Action Classifier - Allied Telesis SwitchBlade x3100 Series Manual

Configuring Classifiers

ADD ACTION CLASSIFIER

Syntax
ADD ACTION CLASSIFIER=classifiername-list { DROP | FORWARD | COUNT
|SETVPRIORITY=0..7 | SETIPTOS=0..7 | SETIPDSCP=0..63 | MOVEPRIOTO-
TOS | MOVETOSTOPRIO }
Adds an ACTION to one or more CLASSIFIERs. As a result, when the CLASSIFIER is
Description
added to a port, the specified ACTION is performed on an incoming packet if the packet
conforms to the CLASSIFIER's match rules, unless the ACTION conflicts with an
ACTION on a matching CLASSIFIER with higher precedence. This command cannot add
an ACTION that conflicts with an ACTION already on the CLASSIFIER.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
CLASSIFIER
ACTION
Example
ADD ACTION CLASSIFIER=ipfilt1 DROP
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Description
Associate an action with a classifier or set of classifiers.
Each classifier is separated with a comma.
DROP - Discard the packet.
FORWARD - Allow the packet to be forwarded. One
action or the other can be assigned, but not both.
COUNT - starts the counting of the actions for the
classifier(s).
SETVPRIORITY - sets the 802.1p bits to the specified
value. This value will impact selection of the egress CoS
queue.
SETIPTOS - sets the IP TOS field (not supported).
SETIPDSCP - sets the IP DiffServ CodePoint field.
MOVEPRIOTOTOS - copies the 802.1q priority field to
the IP TOS field (not supported).
MOVETOSTOPRIO - copies the IP TOS field to the
802.1q priority field. This new value will determine
selection of the egress CoS queue (not supported).
Introduction
Default Value
6-21