Table of Contents
Advertisement
Chapter 1: Overview
LEDs
Installation
Options
Management
Software and
Interfaces
26
Note
SFP and SFP+ transceivers must be purchased separately. For a
current list of supported transceiver modules refer to the GS980MX
Series Data Sheet.
The following restrictions on SFP+ transceivers apply:
100Mbps transceivers are not supported
Supports full-duplex mode only
The port LEDs are:
Link/activity LEDs for the twisted pair ports
Link/activity LEDs for the SFP and SFP+ transceiver ports on all
switches
PoE+ LEDs for the twisted pair ports on the GS980MX/28PSm and
GS980MX/52PSm switches
PoE++ LEDs for the twisted pair ports on the GS980MX/10HSm
and GS980MX/18HSm switches
Full/Half/Collision LEDs for the twisted pair ports on the
GS980MX/28 and GS980MX/52 switches
Switch ID number LED
The installation options are:
Desk or tabletop
19-inch equipment rack
Wooden or concrete wall
The management software and interfaces are:
AlliedWare Plus Management Software
Command line interface (CLI)
Advertisement
Table of Contents
