Add Trace Authdebug - Allied Telesis SwitchBlade x3100 Series Manual

Introduction

ADD TRACE AUTHDEBUG

Syntax
ADD TRACE AUTHDEBUG INTERFACE={ type:id-range | id-range | ifname-
list | ALL } EVENT={ { EAPOL | AUTHSERVER | ACCT } [ ,... ] | ALL }
Adds various tracing parameters for Port Authentication debugging. To see the traces
Description
use the
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Example
ADD TRACE AUTHDEBUG INTERFACE 11.19 EVENT ALL
Info (010017): Operation Successful
ENABLE TRACE OUTPUT CLI
Info (010017): Operation Successful
AuthDbg 2010-10-05 10:34:42.718 DST slot(4) 1
Sent EAP Request(type=1): Supplicant(if=ETH:11.19 mac=01-80-c2-00-00-03
vid=1060)
AuthDbg 2010-10-05 10:34:43.020 DST slot(4) 2
Received EAPOL Start: Supplicant(if=ETH:11.19 mac=00-0d-60-3b-68-49 vid=1060)
6-106
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
ENABLE TRACE OUTPUT
Option Description
INTERFACE The ethernet interfaces over which the trace will be
added.
EVENT Specifies the type of Port Authentication trace to add:
EAPOL - The EAP messages sent and received between
the supplicant and the authenticator (SBx3112).
AUTHSERVER - The Authorization RADIUS packets
sent and received between the RADIUS server and the
authenticator (SBx3112).
ACCT - The accounting messages processed by the
RADIUS server.
ALL - All types of traces are included.
Any combination of the Event types can be inserted
[ ,... ]
here, separated by a comma.
Configuring Port Authentication
command.
Default Value
ALL