Allied Telesis SwitchBlade x3100 Series Manual page 609

Configuring ACL
SHOW ACCESSLIST
Syntax
SHOW ACCESSLIST={ accesslistname-list | ALL } [ INTERFACE={
type:id-range |id-range | ifname-list | ALL } ]
Displays data related to the configuration of ACCESSLISTs and (optionally) associations
Description
by INTERFACEs There are two minor variations of this command: one that shows
ACCESSLIST data for each ACCESSLIST, and one that shows ACCESSLISTs in the con-
text of their associations to INTERFACEs. In both cases the command displays the
ACCESSLIST name, rules, and the action (PERMIT or DENY).
The second case (by INTERFACE) shows only ACCESSLISTs associated with the specified
INTERFACE(s). It also identifies any RULEs that were not able to be applied to the
INTERFACE's hardware, resulting in classifier configuration alarms.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
ACCESSLIST
INTERFACE
Example
SHOW ACCESSLIST stb_range
--- Access Lists ---------------------------------------------------------
Name
--------- -------------- ---- ------- ------------------------------- ---
stb_range ETH:[10.0]
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Description
The ACCESSLIST Name that already exists.
The interfaces that have associated ACCESSLISTs
Interfaces Rule Action
1 DENY
2
3
--
Fields
APPLICATION=NETBIOS
PERMIT IPSOURCE=172.16.5.0
SOURCEMASK=255.255.255.240
PERMIT PROTOCOL=2054
DENY
Introduction
Default Value
ALL
ALL
6-49