Configuring BFD
TABLE 7-20
Step
Command
Enable the service at both ends
ENABLE BFD INTERFACE=1.0, 2.0
3
ENABLE BFD INTERFACE=1.0, 2.0
4
Wait for protocol to be established, then set Detection Multiplier to smaller value (such as the default)
SETDEFAULTS BFD INTERFACE=1.0, 2.0
5
DETECTIONMULITPLIER
SETSETDEFAULTS BFD INTERFACE=1.0, 2.0
6
DETECTIONMULITPLIER
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
Configuration procedure for BFD
Description
At the local end
At the remote end
At the local end, sets to default
At the remote end, sets to default
Introduction
7-125