Allied Telesis SwitchBlade x3100 Series Manual page 98

Introduction
SET IP INTERFACE
Syntax
SET IP INTERFACE={ MGMT | type:id-range | ifname-list | ALL } [
IPADDRESS=ipaddress ] [ SUBNETMASK=mask ] [ IFNAME=ifname ] [ MAN-
AGEMENT={ YES | NO } ]
The SBx3112 only supports a single default gateway, DNS server, and Domain Name, and so these
Note:
parameters do not appear on the SET IP INTERFACE and ADD IP INTERFACE commands.
Changes the existing setting for the MGMT or VLAN interface. If this command is exe-
Description
cuted while the interface is in use, users of the interface must reconnect after the set-
tings are applied by the system.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Example
SET IP INTERFACE=MGMT IPADDRESS=10.52.70.36
SUBNETMASK=255.255.255.0 MANAGEMENT=YES
1-68
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
Option Description
INTERFACE The data packet interface for the system.
MGMT - for the dedicated interface
type:id - for the inband, the VLAN to be used
ifname-list - The names for the interfaces if they exist
ALL - All of the IP interfaces
IPADDRESS The IP address of the system
SUBNET- The subnet mask to associate with the given interface.
MASK
IFNAME A name that can be given for the interface.
MANAGE- Allows MANAGEMENT access to this interface.
MENT
YES - The interface can be used for MANAGEMENT. A
user can Telnet directly into a MANAGEMENT interface
and use it for remote access.
NO - The interface cannot be used for MANAGEMENT.
Configuring the Management Interfaces
Default Value
N/A
N/A
N/A
N/A
YES