Allied Telesis SwitchBlade x3100 Series Manual page 774

Introduction
ENABLE DHCPRELAY INTERFACE
Syntax
ENABLE DHCPRELAY={ dhcpname-list | MAIN | ALL } INTERFACE={
type:id-range | id-range | ifname-list | ALL }
The command ENABLE DHCPRELAY enables the DHCP relay function on the specified
Description
interfaces. Ensure that DHCPRELAY is enabled on the Network-side interfaces.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Example
ENABLE DHCPRELAY=
7-36
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
Option Description
DHCPRELAY The name of the DHCP instance
dhcpname-list - list of specific DHCP instances
MAIN - the default DHCP instance
ALL - all DHCP instances
INTERFACE A logical representation of one or more physical ports;
the INTERFACE to enable DHCP Relay service on.
type:id-range - the type of available ports, such as ETH
or LAG
id-range - used with type (type:id) to query the physical
ports; the numerical identifier of the interface
ifname-list - list of interface names, if not numerical
ALL - all interfaces in the system
x3112 INTERFACE=ALL
Configuring DHCP Relay
Default Value
N/A
N/A