Optical Device Data Access; Optics Data Commands And Output - Allied Telesis SwitchBlade x3100 Series Manual

Optics Data Commands and Output

SHOW TECHSUPPORT FILE (SEC)
Syntax
SHOW TECHSUPPORT FILE=filename [ FORCE ]
Customers can use this command while working with Allied Telesis Technical Support.
Description
When this command is run using the (encrypted) file supplied by Allied Telesis, the out-
put (sent to the terminal) is placed in a file and sent to Allied Telesis Support for further
study.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
FILE
FORCE
Example

8.10 Optical Device Data Access

Cards that use optical devices (SFP/XFP) can have information about these components displayed. The cards
that have SFP/XFP components are:
XE4
•
GE24SFP
•
There are two standards that govern the data format:
SFP: Digital Diagnostic Monitoring Interface for Optical Transceivers SFF document number: SFF-8472, rev.
•
9.5
XFP: 10 Gigabit Small Form Factor Pluggable Module) Revision 3.1
•
8.10.1 Optics Data Commands and Output
The SHOW INTERFACE command has the OPTICS parameter added to specify optics data. When the param-
eter is specified, only the optics data is displayed, along with general data that identifies the interface. The optics
data displayed is a subset of the data contained the SFP/XFP memory. If the OPTICS parameter is not specified,
no optics data is shown, even if the user specifies the FULL parameter.
Software Reference for SwitchBlade x3100 Series Switches (Alarms and Troubleshooting)
Description
Name given to script file by Allied Telesis.
the script execution is displayed directly to the
user's session. The user must capture the output
and place it where Allied Telesis Technical Support
can retrieve the file.
Begins execution of file regardless of customer traffic.
Optical Device Data Access
Default Value
Output from
8-45