Add Trace Epsr - Allied Telesis SwitchBlade x3100 Series Manual

IGMP Counters

ADD TRACE EPSR

Syntax
ADD TRACE EPSR [ ={ epsrdomain-list | ALL } ] MESSAGETYPE={ HEALTH
| RINGUPFLUSH | RINGDOWNFLUSH | LINKDOWN | LINKFORWARDREQUEST |
PERMISSIONLINKFORWARD | QUERYLINKSTATUS | ALL } [ INTERFACE={
type:id-range | id-range | ifname-list | ALL } ]
Add an EPSR trace to an interface. Detailed call events pertaining to a port of set of ports
Description
can be obtained by defining and enabling trace log criteria.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
EPSR
MESSAGE-
TYPE
INTERFACE
Example
ADD TRACE EPSR ALLIED-2 MESSAGETYPE RINGUPFLUSH INTERFACE
ALL
Software Reference for SwitchBlade x3100 Series Switches (Alarms and Troubleshooting)
Description
epsrdomain-list - list of domain(s)
ALL - all domains
Specifies the exact EPSR protocol message type to
trace. Refer to Ethernet Protection Switched Ring
(EPSR) and SuperLoop Prevention
these messagetypes.
HEALTH
RINGUPFLUSH
RINGDOWNFLUSH
LINKDOWN
LINKFORWARDREQUEST
PERMISSIONLINKFORWARD
QUERYLINKSTATUS
ALL - specifies to trace all messages
A logical representation of one or more physical ports;
type:id-range - the type of available ports, such as
ETH:7.0 or a range (ETH:8.0-8.9)
id-range - used with type (type:id) to query the physical
ports; the numerical identifier of the interface
ifname-list - list of interface names, if not numerical
ALL - all applicable interfaces
Default Value
for information on
EPSR Trace
8-29