Setdefaults Authentication Interface - Allied Telesis SwitchBlade x3100 Series Manual

Configuring Port Authentication

SETDEFAULTS AUTHENTICATION INTERFACE

Syntax
SETDEFAULTS AUTHENTICATION INTERFACE={type:id-range|id-range|
ifname-list|ALL} [PORTCONTROL] [REAUTHENABLED] [REAUTHPERIOD]
[QUIETPERIOD] [SERVERTIMEOUT] [SUPPLICANTTIMEOUT]
This command is used to reset the specified Port Authentication interface settings to
Description
their default. If no parameters are specified, all settings are reset. Note that when one or
of these parameters are set back to defaults on an interface, authorization on the inter-
face will drop, and any supplicants on the interface must re-authenticate.
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Option
INTERFACE
PORTCON-
TROL
REAUTHEN-
ABLED
REAUTHPE-
RIOD
QUIETPE-
RIOD
SERVERTIME-
OUT
SUPPLI-
CANTTIME-
OUT
Example
SETDEFAULTS AUTHENTICATION INTERFACE=6.22-6.23 QUIETPERIOD
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Description
The ethernet interface over which the Port Authentica-
tion settings will be set to the default(s).
The authorization state of the port
If set to ON, the reauthentication timer (REAUTHPE-
RIOD) is activated.
The number of seconds that elapse before the suppli-
cant is asked to reauthenticate
The number of seconds, after a failed authentication,
that must elapse before another request can occur
The number of seconds to wait for a response from a
RADIUS server before a time-out is declared.
The number of seconds to wait for a response from a
supplicant before a time-out is declared.
Introduction
Default Value
ALL
AUTO
OFF
3600
60
30
30
6-121