Allied Telesis SwitchBlade x3100 Series Manual page 570

Introduction
TABLE 6-2
Parameter
[IPSOURCE={ipaddress-mask|ANY}]
[IPDSCP={0..63|ANY}]
[IPPROTOCOL={TCP|UDP|ICMP|IGMP|
ipprotocol-number|ANY}]
[MACDEST={macaddress|MULTI-
CAST|ANY}]
[MACSOURCE={macaddress|ANY}]
[PROTOCOL=
{IPV4|IPV6|protocol-type|ANY}]
[TCPPORTDEST={tcp-port|ANY}]
[TCPPORTSOURCE={tcp-port|ANY}]
6-10
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Classifiers (Continued)Match Rules
Description
The source IP address (either host or subnet) of the IP packet.
IP address ranges are specified using a valid IP address or valid subnet and
mask. A range is specified using a '/' character (such as 1.0.0.0/8).
ANY - match all IP packets with any IPSOURCE value.
The code point field with the DiffServ byte of an IP packet. This parameter
cannot be specified with the IPTOS parameter.
ANY - match all IP packets with any IPDSCP value.
The layer 4 IP protocol of the IP packet.
If the command specifies a TCP/IP packet matching rule, (e.g. TCPPORT-
DESC is specified), then the value for this parameter will be TCP. If the
command specifies a UDP/IP packet matching rule, (i.e. the UDPPORT-
DESC parameter is specified), then the value for this parameter will be
UDP.
ipprotocol-number is expressed a one byte hexadecimal or decimal num-
ber.
ANY - match any layer 4 IP protocol.
The destination MAC address for the packet. MULTICAST is for multicast
packets.
ANY - match all packets with any MACDEST value.
The source MAC address.
ANY - match all packets with any MACSOURCE value.
The type field of the payload.
ANY - match all IP packets with any PROTOCOL value.
The TCP destination port of a TCP/IP packet.
ANY - match all IP packets with any TCPPORTDEST value.
The TCP source port of a TCP/IP packet.
ANY - match all IP packets with any TCPPORTSOURCE value.
Classifier Management