Introduction
SET CLASSFIER
Syntax
SET CLASSIFIER=classifiername-list [ VID={ 1..4095 | ANY } ] [
VPRIORITY={ 0..7 | ANY } ] [ INNERVID={ 1..4095 | ANY } ] [
INNERVPRIORITY={ 0..7 | ANY } ] [ ETHFORMAT={ 802.3 | 802.3TAGGED |
802.3UNTAGGED | ETHII | ETHIITAGGED | ETHIIUNTAGGED | ANY } ] [
LSAP={ NETBIOS | lsap-value | ANY } ] [ IPDEST={ ipaddress-mask |
MULTICAST | ANY } ] [ IPSOURCE={ ipaddress-mask | ANY } ] [ IPD-
SCP={ 0..63 | ANY } ] [ IPPROTOCOL={ TCP | UDP | ICMP | IGMP |
ipprotocol-number | ANY } ] [ IPTOS={ 0..7 | ANY } ] [ MACDEST={
macaddress | MULTICAST | ANY } ] [ MACSOURCE={ macaddress | ANY } ]
[ PROTOCOL={ IPV4 | IPV6 | protocol-type | ANY } ] [ TCPPORTDEST={
tcp-port-list | ANY } ] [ TCPPORTSOURCE={ tcp-port | ANY } ] [ TCP-
FLAGS={ { URG | ACK | RST | SYN | FIN | PSH } [ ,... ] | ANY } ] [
UDPPORTDEST={ udp-port-list | ANY } ] [ UDPPORTSOURCE={ udp-port |
ANY } ]
Sets the match rule for the specified CLASSIFIER(s). The match rule specified in this
Description
command replaces any existing match rule on the CLASSIFIER(s). Refer to the options
table for
The following table gives the range of values for each option that can be specified with
Options
this command and a default value (if applicable).
Example
SET CLASSIFIER=ipfilt2 IPSOURCE=ANY
6-28
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
CREATE
CLASSIFIER.
Option
Description
CLASSFIER
The already created CLASSFIER(s), separated by a
comma.
Configuring Classifiers
Default Value