Stacking Slots; Leds; Installation Options; Mac Address Table - Allied Telesis x510 Series Installation Manual

Stacking Slots

Two SFP+ slots can be used with special stacking transceivers to create a
VCStack of up to four switches that operate as a virtual switch. Here are
the basic features of the stacking slots on the x510 Series switches:

LEDs

Here are the port LEDs:
Installation
Here are the installation options for the switches:
Options
MAC Address
Here are the basic features of the MAC address tables of the switches:
Table
Management
Here are the management software and interfaces:
Software and
Interfaces
Management
Here are the methods for managing the switches:
Methods
Note
SFP+ slots 27 and 28 on the AT-x510-28GTX Switch and slots 51
and 52 on the AT-x510-52GTX Switch are initially configured as
stacking slots for the VCStack feature. If you intend to use the switch
as a stand-alone unit, you must disable the VCStack feature before
you can use the slots with standard SFP or SFP+ transceivers. The
configuration instructions are provided later in this guide, in
"Configuring the Switch for Stand-alone Operations" on page 62.

Two stacking slots per switch
 40Gbps stacking bandwidth
 Duplex mode and link/activity LEDs for the twisted pair ports
 Link/activity LEDs for the SFP+ slots
 Stack ID number LED
 eco-friendly button turns off the LEDs to conserve electricity

19-inch equipment rack
 Desk or tabletop
 Storage capacity of 16,000 dynamic MAC address entries
 Storage capacity of 256 static MAC address entries
 Automatic learning and aging

AlliedWare Plus Management Software
 Command line interface
 Web browser interface
 Local management through the Console port
 Remote Telnet and Secure Shell management
x510 Series Installation Guide for Stand-alone Switches
17