Allied Telesis SwitchBlade x3100 Series Manual page 508

Introduction
4.9.3.3 Configuration Procedure
TABLE 4-27
Step Command
Create the port-based HVLAN
CREATE HVLAN=H_100 VID=100 TYPE=PORT-
1
TUNNEL
Set the Network interfaces to a TPID value
SET INTERFACE=0.1,0.2 TPID=0x9100
2
Associate HVLAN with Network interfaces.
ADD HVLAN=H_100 INTERFACE=0.1,0.2
3
FRAME=TAGGED
Associate HVLAN with line card ports.
ADD HVLAN=H_100 INTERFACE=2.0,2.1
4
FRAME=UNTAGGED
Disable IGMP and DHCP on the customer interfaces
DISABLE IGMP INTERFACE=2.0,2.1
5
DISABLE DHCP ALL INTERFACE=2.0,2.1
Set line card interface to TAGALL=ON
SET INTERFACE=2.0,2.1 TAGALL=ON
6
Observe the configuration
SHOW HVLAN FULL
7
--- HVLAN Information ---------------------------
Type.................................. HVLAN - port tunnel
Name.................................. H_100
Identifier............................ 100
Status................................ static
Forwarding Mode....................... Standard
IP module attached....................
Untagged interfaces................... ETH:[2.0,2.1]
Tagged interfaces..................... ETH:[0.1,0.2]
Tunneled VLANs........................ n/a
4-188
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
Configuration Procedure for Port Based HVLAN
Configuring Port Based HVLAN
Description
Creates a port-based VLAN tunnel.
Set this only when sure that the Network inter-
face is expecting this value.
Note: This step is only needed when connecting
to a non-Allied Telesis device.
Adds a tagged HVLAN to Network interfaces.
Adds an untagged HVLAN to Customer inter-
faces.
On Customer interfaces, ensure IGMP and DHCP
are correctly configured.